Lunarpages IMAGEMAGICK problems???

[nbramley]

I've successfully uploaded EE to my webhost provider, Lunarpages and have had no issues until a few days ago. Is anyone else experiencing problems with IMAGEMAGICK and the resizing of images??? Below is the error I'm getting:

msg 19921 | internal ftp: 100088.jpg: UPLOAD ERROR. Reason: readfile(IMAGEMAGICK FAILED100088.jpg): failed to open stream: No such file or directory

It also gives me a list of possible problems:

POSSIBLE REASONS:

SAFE MODE ON? EE can not use ImageMagick when is it located outside PHP safe mode exec dir.
IMAGE IS EMPTY? Perhaps source image was zero size.
IMAGEMAGICK PATH CHANGED? Maybe your server admin has moved IM to another location.
FOLDER PERMISSIONS WRONG? check that UPLOAD folder and all folders inside it are chmod 0777 (full permissions)

Anybody have any ideas???

Neil

[Pekka]

Check all EE's temp directory permissions. Check also the the disk/quota is not full.

[photocroatia]

I had a problem with Lunarpages a few days ago when they moved to some new software where I had to change the permission of my folders to 755.

Are you on Valina? If so, then you might have the same issue.

I hope that helps.

[Pekka]

I had a problem with Lunarpages a few days ago when they moved to some new software where I had to change the permission of my folders to 755.

Are you on Valina? If so, then you might have the same issue.

I hope that helps.

More specifically: all php and image files to 755, temp and upload folders to 777. Also .htaccess is not allowed any more, use local php.ini instead.

[PrimaPhoto]

The installation of EXHIBIT ENGINE 1.5 RC 4 went pretty well last night, but I was informed by my server admin person that I do have Imagemagick installed on my server and was provided with the path.

In Moduale set up I have GD1 ACTIVE can I activate Imagemagick also?

I can't seem to get Imagemagik intalled? checked EE Forum and found info about CHMOD.
For example I entered my Imagemagik path like this example /usr/X11R6/bin/ for the convert path and composite path.

Thanks

Mark

[kad01]

I had some similar problem with ImageMagick some days ago after my ISP have done a serverupgrade. I could only get IM to work with a radius of 1.0 or higher.

[PrimaPhoto]

I tried again today but couldn't get it to work. I think I'm just going to stick to GD, it's working.

I think I'll have enough work getting my photos up and learning the new version.

Mark

[xahmol]

Did you already read the thread http://photography-on-the.net/forum/showthread.php?t=34738&highlight=lunarpages+imagem agick on this forum?

Setting the paths to the paths below solved my ImageMagick problems at Lunarpages Valina server:
"Path to Imagemagick's 'convert' program is"
/usr/local/bin/convert

"Path to Imagemagick's 'composite' program is"
/usr/local/bin/composite

[PrimaPhoto]

Thanks xahmolÂ*Â*for being of assistence. I got it to work But I still can't get EE to view my images actual size? I did go in to Resize Method Editor and picked Big sizes >> then ImageMagik and set it to 100%. When I click on PREVIEW THIS SIZE NOW the image does not appear?

Almost there...

Thanks again

Mark