PDA

View Full Version : ABR800 to Pocket Wizard cord?

pepperoni
15th of February 2008 (Fri), 16:56
Just got the ABR800. So far, so good, but does anyone know what cord to I need to connect a PW to it?

Thank you.
PacAce
15th of February 2008 (Fri), 17:01
Just got the ABR800. So far, so good, but does anyone know what cord to I need to connect a PW to it?

Thank you.
Assuming the ABR800 uses the same miniphone plug as the other AB strobes, all you would need is a short male 1/8" (3.5mm) mono miniphone plug to male 1/8" mono mini phono plug. And if you get it from a place selling audio cables, like Radio Shack, make sure it's not the attenuating type of cable.
pepperoni
15th of February 2008 (Fri), 18:46
Right on. Thanks.
FlashZebra
15th of February 2008 (Fri), 22:39
make sure it's not the attenuating type of cable.
PacAce, no interest in seeing the same mystery movie again?

Pepperoni, you need a cord that suits your length needs with a MONO miniphone plug on one end, and a MONO miniphone plug on the other end.

Enjoy! Lon
pepperoni
16th of February 2008 (Sat), 00:39
Lon,
Do you have the cord I need?
PacAce
16th of February 2008 (Sat), 00:44
Lon,
Do you have the cord I need?

I didn't see any when I looked the last time and that's the reason I didn't mention it. But I searched a little harder and did find it.

http://flashzebra.com/wizardcables/index.shtml

You'll be able to use #0062 and #0018.
pepperoni
16th of February 2008 (Sat), 12:50
Perfect.
Thanks, Leo!
:)