Need help with Avenger A700 boom stand

[Papa Carlo]

So following a general disease from infection flying in this forum I gave up and bought myself A700 boom stand.
I was so stunned by the size of the thing that I kept rotating the clamp that holds the boom in place until the handle fell on the floor together with a washer and a ball bearing
I put everything back but I am not sure I did it correct.
Would somebody be so kind to look at the assembly and tell me the correct order and position of the parts. For example which way to insert the ball bearing.

[Papa Carlo]

OK, I admit that nobody uses Avenger A700 stand :-(

[Jannie]

Now I'm afraid to take it apart, ball bearing? I took the thread tensioner off a sewing machine and finally had to replace the whole machine.

[Rudi]

OK, I admit that nobody uses Avenger A700 stand :-(

People use it, they just don't take it apart! ;) Email Bogen or Manfrotto directly, they should be able to help you.

[doidinho]

Here you go. The opening in the encased bearing should be faced toward the handle. Good Luck.

[J Kacey]

So following a general disease from infection flying in this forum I gave up and bought myself A700 boom stand.

Nice isn't it?


I was so stunned by the size of the thing that I kept rotating the clamp that holds the boom in place until the handle fell on the floor together with a washer and a ball bearing

Righty Tighty, Lefty Loosey:)

[Rudi]

Righty Tighty, Lefty Loosey:)

:lol: Priceless! :D

[Andrushka]

Nice isn't it?


Righty Tighty, Lefty Loosey:)

ahh yes wisdom for the ages :lol:

[Papa Carlo]

Here you go. The opening in the encased bearing should be faced toward the handle. Good Luck.
Thanks Robert ! That is tremendously helpful !
Tell me where to send a beer ! :-)