Need information on the Canon RS60E3 Remote

[kanewtz]

Hey Guys,
So, I've searched the forums but really can't seem to find the information I am looking for.

I have an opportunity to buy a used RS60E3 for my Canon EOS Rebel XSi. However, I was inside a local Henry's and they informed me that the remote will not work with my XSi and that I would need a wireless one.

My question is, will that remote in fact work with my XSi? If it does work, should I pick it up or should I get the RC-1?

Which is better in your opinion.

[Beachcomber Joe]

Both the RC-1 and the RS60E3 work with the Xsi. The RC-1 is an infrared remote which must be pointed at the front of the camera body. The RS60E3 is a wired remote that plugs into the camera body. Both allow you to do bulb exposures as well as conventional exposures.

[kanewtz]

Anyone have information on this? It will be greatly appreciated :)

[Jon]

Like Beachcomber Joe said, the RS60E3 will work just fine on the XSi. Canon lists it as one of the available accessories here (http://www.usa.canon.com/consumer/controller?act=ModelInfoAct&fcategoryid=139&modelid=16307#SNAModelSuppliesAct). It's also listed on p. 164 of your XSi manual. Can't get much more authoritative than that.

[kanewtz]

Thank you very much...I have decided on the wired remote vs the wireless. Apparently there are quite a few limitations on the wireless remote.

I also read that all you need to do is connect a 3.5mm headphone cable to extend the distance of the remote. Is there any truth to this?

[Jon]

Yes, as long as it's a stereo headphone extension cord.

[kanewtz]

Perfect. Thank you all for your help. You have been more than helpful to me.