Sekonic L-358 Am I Doing something wrong?

[Gary_E]

just got my sekonic w/rt module 32 for pocket wizard and i cant get the radio transmit icon up. the module is plugged in any ideas?

[scottbergerphoto]

I assume you held down the Mode Button and turned the dial?
Try removing and reseating the module. It may be a bad module.

[Gary_E]

I assume you held down the Mode Button and turned the dial?
Try removing and reseating the module. It may be a bad module.
thats what i think i reseated the module a few times followed the instructions about the mode but no luck. guess i have to call adorama and bring it back. one of the monolites i bought was bad bh took it back no problem..

[defordphoto]

I have the 358 and also the RF module. Works great! Let me check it when I get home tonight to see if I can help before you return it. It was a bit of a challenge to get it working if I remember right.

[Todd Jacobsen]

When I purchased my L358, I had a hard time getting the transmitter mod to fit. I was afraid I would break a pin. It finally fit and now works great.

You probably already did this but you need to be in TRANSMITTER mode for the PW mod to work. It will not work in any other mode. Same holds true for sync cord (need to be in Sync cord mode).

I do not believe a dip switch pins need to be adjusted, I remember adjusting my dips but I believe it was for other reasons.

[Gary_E]

i took a day off work today im going to run over to adorama and exchange it.. as far as i understand w/the module seated you hold the mode button down while turning the wheel and you go into the transmit mode. but i dont even show the transmit icon, i suspect the module is bad

[scottbergerphoto]

Your understanding is correct. Good luck at the store.

[Gary_E]

Your understanding is correct. Good luck at the store.
it wasnt me.. the meter was defective the transmitter module was good..
end of story for now..

[scottbergerphoto]

Well done Gary. ;)