car rigs?

looking to put together a car rig or if you have any suggestions on someone that sells a good kit.

this is what im looking at
http://www.bhphotovide​o.com/c/produc...ion_M​agic.html

http://www.bhphotovide​o.com/c/produc...with_​Baby.html

http://www.bhphotovide​o.com/c/produc..._Cup_​with.html

http://www.bhphotovide​o.com/c/produc...p_wit​hout.html

Three Aluminum Piping Sections, 1.5" Diameter Approximately, 4-5' in length

your links are busted.

manfrotto magic arm
avenger f1100 pump cup without swivel
2 avenger f1100 suction cup with baby swivel
4 manfrotto superclamps
and the aluminum pipe

thekid17 wrote in post #15980701
manfrotto magic arm
avenger f1100 pump cup without swivel
2 avenger f1100 suction cup with baby swivel
4 manfrotto superclamps
and the aluminum pipe

So are these the only parts needed? it doesn't sound like it is expensive. Rig-pro sells them for $900 which is very expensive comparing it to buying the parts separately.
I would like to hear from someone with experience.

Ibrahim.Photography wrote in post #15984853
So are these the only parts needed? it doesn't sound like it is expensive. Rig-pro sells them for $900 which is very expensive comparing it to buying the parts separately.
I would like to hear from someone with experience.

But the piece it together your self way requires you to actually create the aluminum piece so the interlock with eachother and make the support cable and fabricate all tabs and what not. So factor in your time to do all that along with the cost of the aluminum the mark up on all the other parts needed like the clamps and you will probably sit around the same price range.

DIY is only cheaper if you have the skill to fab the parts that you can not just purchase from B&H or any other retailer.

Sevan

my rig in total will cost like 430 bucks with a aluminum

Official Automotive Rigs - DIY Thread

thekid17 wrote in post #16036635
my rig in total will cost like 430 bucks with a aluminum

Do you mind sharing your rig parts and setup?