L Bracket for Canon T4i?

I have an inexpensive Arca Swiss compatible L bracket for my Canon T4i.

It was reasonably priced, and while it's usable even with the remote plugged in, it's a little tight fit with the rubber panel open.

Does anybody have a recommendation for an Arca Swiss compatible L bracket that's a better fit for a T4i?

Thanks.

My default answer would be RRS

Hokie Jim wrote in post #18296346
My default answer would be RRS

Unfortunately, I didn't see anything specific to the T4i. I haven't seen anyone else with anything either.

I use a ProMediaGear L bracket on mine. But I think all of the L brackets are going to be a tight fit. They have to be to allow the swivel screen to have full range of motion.

troehr wrote in post #18316537
I use a ProMediaGear L bracket on mine. But I think all of the L brackets are going to be a tight fit. They have to be to allow the swivel screen to have full range of motion.

Thanks for the answer. At this point, I just line up the plate so there's just enough room on the left for the rubber panel and the cable, while not having it too far off center. or blocking the batter compartment door. There's somewhat of a tendency for it to want to rotate, but there will always be that with a plate that doesn't conform to the body shape.