I recently purchased a Creality Ender-5 Pro 3D printer and looked for flash diffuser projects. I found this:
https://www.thingiverse.com/thing:2937555![]()
About 18-hour print job on the Ender-5.
Photos of the diffuser installed on a Yongnuo YN560 III, a bit of gaffer tape to hold it in place. With older/smaller flash units, such as YN468, install some foam strips inside the throat of the diffuser. This is stated to also fit Canon Speed-lites, but I don't have any to test.
Some simple shots, this afternoon, in my garden, using the diffuser. No processing other than converting to .jpg and reducing the file-size for web viewing.
If you build one of these, consider giving the designer (not me) a tip.







