Official Automotive Rigs - DIY Thread

ole61 wrote in post #10275320
very dynamic shot, great - did you push or drive the car?

Drove it

The new Honda S2000 - It will pick you up

SamHunter wrote in post #10279930
The new Honda S2000 - It will pick you up

ahahahahaha

It's a sick shot, but damn that messes up everything

SamHunter wrote in post #10279930
The new Honda S2000 - It will pick you up

OIC what you did there.

Quick question!

Ive got a under-slung rig at the moment.. but thinking of getting some suction cups!

The avenger F1000 seem to be the choice but the are only rated at 2kg... is that enough??

Rich

richwig83 wrote in post #10284525
Quick question!

Ive got a under-slung rig at the moment.. but thinking of getting some suction cups!

The avenger F1000 seem to be the choice but the are only rated at 2kg... is that enough??

Rich

2kg is a bit understated I think.

I have a set of suction cups from Film Tools and they are rated at 100lbs or so.

i have two f1000s and no problems thus far.

my cups are rated at 6lbs each...I hung a 15-20 lb bag on it over night and it did not move.

Supra_t wrote in post #10265526
Is it too early to ask what CS5's content aware fill is like for removing the rig?

It helps, but it's not fool proof. You still need to go back and do some cloning and air brushing to do a good job.
---------------

Here are some rig shots of this Audi A4 I did the other night.

Cool... looks like a pair of F1000 are in order then!

Anyone want to by under car clamps??

richwig83 wrote in post #10289488
Cool... looks like a pair of F1000 are in order then!

Anyone want to by under car clamps??

It`s important, to check the avengers working right - I did send cups two times back to the dealer because they didn`t work.

Now I have two avengers making no problems but normally I support them with a additional veribor suction cup and a cable on the boom on the other side of the car - I`don`t like it to feel nervous ...

Supradedupra wrote in post #10289319
It helps, but it's not fool proof. You still need to go back and do some cloning and air brushing to do a good job.

can you please do some before and after shots without any cloning just to see what cs5 fill can do to the rig? thanks

If I have time tonight I'll do a before and after... I didn't expect it to be magic but there's still a fair amount of work required after you use the content aware

thank you i appreciate it, yeah i just would like to know how much it helps. not really expecting it to make our job any easier...lol