Dust delete data??????????

I'm running dpp 3.5.2
With my 5D,when i try to use this feature..it is greyed out?
I'm forced to use the stamp tool instead..
Just wondering why the dust delete feature is not working

Any help/suggestions would be appreciate
Thanks
Mike

This function is relatively new. IIRC, it began with the 1DIII. At any rate, the 40D supports it but the 5D doesn't.

tzalsman
Thanks for your reply..
Not working on the 5D?,of course,just my luck,this is the canon body that needs it the most....

hmmmm..doesnt work on the 40D either...strange!!!

Have you created the dust map? You do that by shooting a white sheet of paper. The camera identifies the locations of dust particles and appends the data to the CR2 metadata. Instructions on page 129, 40D manual.

If in doubt, look in the instruction manual!

Elie,Roy
Thanks for your replies
Maybe its time I..rtfm

Thanks
Mike

mike397 wrote in post #7253440
Elie,Roy
Thanks for your replies
Maybe its time I..rtfm

Thanks
Mike

What does this mean?

^^ http://en.wikipedia.or​g/wiki/RTFM

Thanks for the link thaking. (Thinks - why can't people speak/write English?)

i guess cause it is more polite to write RTFM rather that "f*%king"...

Thank you ,thaking!!!!
Guess it depends what side of the pond your on,check?

just clean your sensor?

thaking wrote in post #7255604
i guess cause it is more polite to write RTFM rather that "f*%king"...

It's even more polite just to write RTM or Read the Manual

Roy Mathers wrote in post #7258352
It's even more polite just to write RTM or Read the Manual

But it doesnt quite carry the same impetus does it?