This is probably a very thick question but I've read the manual and still can't seem to get it right ....
I have my settings done for weddings and have registered them as SET1 ...
I have another set kindly given to me for a starting point for tracking etc ....
These are CAMSET03.CSD
I load these into the camera and save them as SET2 ...
Low and behold set 1 has disappeared ...
I don't know what I am doing wrong but I CAN
save the same set to SET1 and SET2 and then manually go through the functions and alter them and save over the top of one of the sets - so I do end up with two different ones....
My questions are:
1. Is there an easier way
2. what is the quickest method for changing sets
Thanks
Simon
